CNR 3737 :: Pilot details

CNR 3737 - pilot details

This morning, I put my new workshop chair to good use by adding more details to the pilot of CNR 3737. As the photo shows, the pilot beam now sports a coupler cut lever and flag holders. I also added four safety-tread steps – large ones in the lower corners, and small ones above the boiler tubes on either side of the coupler draft gear housing.

There are a few more details to add, such as piping from the air tank and a train line and signal line. But the pilot is otherwise complete and I can move on to the next part of this project. Andy Malette and I have another work session planned for later this week…

9 thoughts on “CNR 3737 :: Pilot details

Leave a Reply

Your email address will not be published. Required fields are marked *

Please prove you're not a nasty spamming robot thingy * Time limit is exhausted. Please reload CAPTCHA.

This site uses Akismet to reduce spam. Learn how your comment data is processed.